Created 11/22/2000
Step by Step pictures of building a Fogged airbox.
Parts to make the inlet.
Seperating the 4" section from the reset of the adapter.
Building the rodent screen
Soldering the rodent screen into the inlet
Getting started on the airbox
Unhooking the inner frame
Removing outer funnel from airbox
Picture of factory hole
Getting ready to cut new 4" hole
Cutting hole
New hole
Test fitting inlet
Expanding hole where needed
Making clearance for inlet
Inner support removed
Washing airbox
Inlet in place
Inlet hot glued
Inlet glued inside
Airbox completed!
Back to homepage